 |
Prepare
cable end and connect to Sub D Connector leaving enough
wire or braid for assembly to the ferrule as detailed
below.
Select
the ferrule halves that most closely match the diameter
of the cable (the halves do not need to be matching).
|
 |
Option
1
Insert the wire through the hole of the ferrule as
shown in Fig 1. Assemble the two halves of the ferrule
around the cable making sure that the cable insulation
runs the full length of the ferrule, then complete
as in Fig 2.
|
Loop
the earth wire around the earth recess as shown.
Slot
the assembly into the lower half of the hood making sure
that the earth wire is showing from under the contact area
of the ferrule assembly [Fig 2].
The
earth wire can be insulated and extended to a contact on
the connector if required.
 |
For
heavily braided cable, pigtail the braid, and bring
it back over the assembled ferrule [Fig 3].
For
light braided cable pigtail the braid and bring it
back in one direction only. Inroduce the assembly
into the hood and complete the hood assembly.
|
|
